In recent years, unsaturated/saturated vertical flow constructed wetlands(VFCW) treating raw wastewateraregradually considered as apromising solution for their adaptation under various climatic conditions. These facilities provide surface optimization but alsobetter treatment efficiencies compare to classical French VFCW.The main performance improvements are: SS entrapment and carbon consumption for denitrification within saturated layer.When total nitrogen, by nitrification and denitrification,istargeted in the two successive zones, a design compromise has to be fund between nitrification efficiency and available carbon source for denitrification. As performance largely depends on unsaturated and saturated layers depths,a better understanding of their quantitative effects on treatment performance is essential for the adaptation of this system under various installation conditions. The aim of this study was to estimate the influence of these two linked design parameters onN efficiency with a focus onremoval limitations in regard to nitrogen loads. For this purpose, two different pilot-scale experimental configurations were designed: (i) 45 cm of unsaturated and 25 cm of saturated layers and (ii) 55 cm of unsaturated and 35 cm of saturated layers. The mature pilots were operated over 5 months using real wastewater with a feeding/resting period cycle of 3.5/3.5 days with a daily hydraulic load of 0.36 m d-1.In order to vary inlet nitrogen loads, ammonium nitrogen enrichments were added to vary loads from 10 to 40 g N m-2 d-1.24h flow composite samples at inlet and outlet of each pilot were semiweekly collected and analyzed for the following parameters: total suspended solids (TSS), total and dissolved chemical oxygen demand (COD), Kjeldahl nitrogen (TKN), ammonium, nitrate, phosphate and sulfate. Online measurement on a minute time step were done for inlet/outlet flows, oxygen content at three different depths, outlet ammonium and nitrate concentrationsby ion specific probes, and temperature. The paper will present the performance and limitations ofthe two configurations.Dynamics of nitrogen removal processes will be discussed in relation to physicochemical conditions (temperature, oxygen content, hydraulic retention time, carbon sources, etc.).